|
Help needed please give advice
Ok guys been a looooooooong 2 weeks, went to install new heads some aftermarket ones to replace the ported stockers and had some issues with the block. I had cleaned an tapped all head bolt holes but after being taken apart 5 times, 3 out of the 20 head bolt holes didnt want to stay part of the block. Found this to be a common problem when TTY bolts are used several times. I had switched too ARP head bolts this last time cus i hate TTY. Had my torque wrench calibrated 2 months ago so know that was good. But on that second pass bam.
So removed the block and had inserts put in all 20 to make sure they were strong and good. Put it all back together with new Johnson 2110r drop ins as i had the proper pushrods for them. Checked all the wires and connections all seems peachy. Car started right up sounds great and fell into a good idle. But i had codes galore for some reason but its running great tried clearing with my HP tuners but doesnt go away. Any thoughts?? Heres a screen shot
|