[Tbone98]

I'm sure this is easier then I am stressing about, but one of my 3 items I sent to the dealer as "no, no's" was to not drill holes in the front bumper for a license plate mount. WELLLL, they did not drill and/or add the RR license plate holes and anchors.

I pretty much assume its easy, but I am freaking about scratching the area. Has anyone done this before and can offer instructions?

Do you drill one larger hole and push the square frame anchors through the round hole?
Do you use a smaller bit and drill multiple holes to essentially make a square pop out?

There are multiple dimples on the plate area but don't seem to be mirrored left to right

thanks