Quote:
Originally Posted by Joshinator99
I was under my car the other day and your thread popped into mind when I was under the transmission. So I decided to take a peek at what replacing the cable would entail and it did NOT look fun lol…glad you were able to get it. I’m assuming this would be much easier to do if you had the transmission out for one reason or another?
|
If the trans is out much easier yes.
Still need to take apart the dash but at least you can drop the cable right down the hole with no obstruction an inch away from the hole
__________________
928rwhp - 93 | 1040rwhp/898rwrq - E65 SAE
LME 377 LT4 Short Block | Magnuson 2650 80mm upper w/13% lower (9.06) | DSX Lid & Valve Covers | CSP Custom Cam w/32% fuel lobe | CID Heads | NW 103mm TB | Roto Fab Big Gulp | CSP 2" Headers w/Green GESI Gen 2 Cats | Borla 3" Full Cat Back w/ S-Type| Mighty Mouse Wild Catch Can| Custom Holley Low side Fuel system| TooHigh PSI Port Injection w/Holley Controller | Forced Inductions Interchiller w/2 gallon fender tank | TK Performance built 10L90