View Single Post
Old 08-07-2023, 11:18 AM   #2
Camaro1973

 
Camaro1973's Avatar
 
Drives: 2019 ZL1
Join Date: Mar 2019
Location: NJ
Posts: 1,537
Just wanted to update this. I was able to replace the entire cable.

What a nightmare. You have to take half the dash apart to get to the damn 2 inch hole that sits far back way behind the ac duct in front of center console.

Then you need to snake the cable which is almost as wide as the hole down to the trans.

The trans is right below the damn hole so it needs to go in/out on an angle or it just gets stuck. I removed the trans mount so the trans lowered and was able to push it out.

Putting the new cable in i snaked a fish stick through the top hole, zip tied end of cable and began pulling it up through the top. Of course it got stuck on the fat part of the cable hitting the trans and trying to make it through the hole.

After breaking my hand so I could turn it backwards I finally pulled that damn thing through.

I don’t want to ever do this again
Attached Images
   
__________________
928rwhp - 93 | 1040rwhp/898rwrq - E65 SAE

LME 377 LT4 Short Block | Magnuson 2650 80mm upper w/13% lower (9.06) | DSX Lid & Valve Covers | CSP Custom Cam w/32% fuel lobe | CID Heads | NW 103mm TB | Roto Fab Big Gulp | CSP 2" Headers w/Green GESI Gen 2 Cats | Borla 3" Full Cat Back w/ S-Type| Mighty Mouse Wild Catch Can| Custom Holley Low side Fuel system| TooHigh PSI Port Injection w/Holley Controller | Forced Inductions Interchiller w/2 gallon fender tank | TK Performance built 10L90
Camaro1973 is offline   Reply With Quote