[Camaro1973]

Hey guys, I’m having an issue where the shifter cable is popping off the trans linkage because the crappy plastic piece and end of cable is worn out. Probably from removing it 100 times.

I ordered a new shifter cable but I’m not sure if I can just take off the end piece that pops on the tranny, or take that bushing out if the new cable or if I have to replace the entire cable. The end piece looks to be threaded onto the adjuster rod, I just don’t know if that rod is hollow and the cable runs through it or I can unscrew the entire black end piece.

Does anyone have any diagrams or has done this before? I’ll replace the entire cable if I have to I just don’t know how difficult it is.

Here’s the pic of the cable.