Thread: IAT QUESTIONS
View Single Post
Old 05-02-2023, 05:40 PM   #6
Camaro1973

 
Camaro1973's Avatar
 
Drives: 2019 ZL1
Join Date: Mar 2019
Location: NJ
Posts: 1,537
Quote:
Originally Posted by SOCAL.M6.ZLE View Post
Hey Team, trying to get back in the car, and finish my tuning since my phase.2 mods were completed. Had alot on my plate, eager to get it tuned.

Aside from a scary amount of power, having traction issues even at 100mph in 4th with new 345 rear R888R's
Not sure my boost level yet, guessing around 13 pounds +/-

Ported blower, with a 2 gallon expansion tank and larger intercooler...

Driving around last night, cruising on the freeway, 60-65 IAT.1 (ambiant)

and IAT.3's between 110F +/-

After a 4th gear partial pull... up to 130F, drops quick.
Surface streets, same temps, average 120-130F, can get up to 140-145F at a stop light...

Sounding normal?

All normal, the extra capacity is helping a bit.


A few back to back pulls though will yield a different story, especially when your in warmer ambient temps.
__________________
928rwhp - 93 | 1040rwhp/898rwrq - E65 SAE

LME 377 LT4 Short Block | Magnuson 2650 80mm upper w/13% lower (9.06) | DSX Lid & Valve Covers | CSP Custom Cam w/32% fuel lobe | CID Heads | NW 103mm TB | Roto Fab Big Gulp | CSP 2" Headers w/Green GESI Gen 2 Cats | Borla 3" Full Cat Back w/ S-Type| Mighty Mouse Wild Catch Can| Custom Holley Low side Fuel system| TooHigh PSI Port Injection w/Holley Controller | Forced Inductions Interchiller w/2 gallon fender tank | TK Performance built 10L90
Camaro1973 is offline   Reply With Quote