|
It helps if you've done an axle back, or just cut the pipes where an axle back would go so you could loosen the muffler. I think that's how I did it. It wasn't bad. I wrapped the tips in towels, too, so when it swung down-ward, the tips just didn't ramrod the facia. It wasn't bad after that.
__________________
'20 ZL1 Black "Fury"
A10, PDR, Exposed CF Extractor
Magnuson Magnum DI TVS2650R // RFBG // Soler 103 // TooHighPSI Port Injection // THPSI Billet Lid // FF // Katech Drop-In // PLM Heat Exchanger // ZLE Cradle bushings // BMR Chassis-Suspension Stuff // aFe Bars // Diode Dynamics LEDs // ACS Composites Guards // CF Dash // Aeroforce // tint // other stuffs |