Quote:
Originally Posted by Sephx1
Jus curious if anyone else has had this problem. One of my Accel wires came apart when I was changing plugs so I decided to go with a new set of Ganatelli wires after reading positive reviews here. I didn’t get very far, on the 2nd plug wire from the back on the driver side the plug wires is pushing up tight against the header. My accel wires were angled and didn’t have this problem. I don’t think you would want anything touching the headers… Not sure what brand they are, they came with the car.
|
They are bendable, bend them to fit.
__________________
928rwhp - 93 | 1040rwhp/898rwrq - E65 SAE
LME 377 LT4 Short Block | Magnuson 2650 80mm upper w/13% lower (9.06) | DSX Lid & Valve Covers | CSP Custom Cam w/32% fuel lobe | CID Heads | NW 103mm TB | Roto Fab Big Gulp | CSP 2" Headers w/Green GESI Gen 2 Cats | Borla 3" Full Cat Back w/ S-Type| Mighty Mouse Wild Catch Can| Custom Holley Low side Fuel system| TooHigh PSI Port Injection w/Holley Controller | Forced Inductions Interchiller w/2 gallon fender tank | TK Performance built 10L90