|
Kooks and wiring loom?? Question
So i read on here that several guys had burned their wiring loom on the passanger side. So i have just done my kooks 1 7/8s headers last week and decided to take a look. There was nothing in Kooks literature about moving or anything with that loom. But upon taking my coolant take up out of the way i did see it was a bit close. Not horrible but lil closer than id like. So i made sure the two clips securing it to the frame were in and secure ... check. Then i started thinking of ideas. I have a small piece of angle metal 1 in by 1 in and i am.goin to drill a small hole in it and then bend the side with a small lip so the wiring harness can be held all the way against the wall. For the time being i found some reflective heat wrap with sticky back cut it into 5 strips and wrapped the loom all along the area of concern and then zip stripped them to keep them tight. This added rigidity to it as well and made it move over further. Like to hear thoughts on this thanks
|