|
I believe the fronts will also work on the rear. You'll stick out about 3/8" further toward the fender, and gain a ton of clearance on the inside (1-3/8"), but I think it should work. I'm sure someone has tried it and can confirm, though. It should work strictly by the offset calcs though. Meaning, 20x10 et20 on all corners.
__________________
2017 ZL1 M6 Black | Maggie 2650 // 103TB // Big Gulp // CSP LT's & Ultra Cats // BMR MM // BC Forged KL13
Mods being installed-
oil pump, cam, ported heads, dual in-tank, Goliath and XDI, corn, etc., etc.
|