Quote:
Originally Posted by Kerry
it certainly is not impossible pulling tractors run over a 100 psi. O mullet put 45 in Steve Morris 35 pd engine and blew it lol.
But in my case the stats are
14.7 is seal level. Im saying that it went to 19 to 20 plus above vacuum because when the motor is running, their is vacuum right. or u could say about 230 kpa total if that helps.
The pressure was 14.36 at the dyno location.
So with out boost the engine can get to about 0 pressure wide open witch would = atmosphere or theoretical 14.7 but was 14.36 in this case. Boost is all above that.
|
That's lower than what I would expect, but I'm not a meth guy:
20.00
-14.36
5.64 psia boost
__________________
2020 ZL1LE A10.
LME LT4 390 short block, LME CID Heads, Kong E2650, FBO.
15" conversion, MT ET Street R 325/15.
100 octane: 1045hp/1055tq.
100 octane + Meth (1x10+): 1117 hp/1067 tq
|