Quote:
Originally Posted by JSH
The current top pulley generates 23,500 rpm which is toward the upper end of Eddie's range. But Greg agrees with you that 140F-ish isn't that bad, but I'm going to put larger lines on it in hopes of lowering temps. And also put the 3" back on it until March. Davies Craig says larger lines are the simplest way to reduce temps.
Of course I could do meth too.
|
140 isn’t bad because that’s probably the average of where mine runs. Like King said, if it’s not being way over spun it should hold. Most of the time mine holds the same temp before going WOT and sometimes even cools down. With that much pulley you may be boost stacking as well. Might pick up power slowing the blower down.