Quote:
Originally Posted by Evansa22
Nice, so you decided to have them port the heads? Good choice if so! Might as well get it knocked out while it's all apart
|
Yeah... trust me i have everything to do it myself, except the time. I was also worried about getting the runners to match. Found a local flow bench for $200 to flow both heads, but then would have also needed to purchase a stock sized set of valves to clean up the CC, and a 90% smaller valve to open the throats... once done, figured the cost would have been the same, and would be silly to think i could do as good as the CNC file... i'll still end up cleaning them up a little when i get them back just to make myself feel better
Also going to port match the blower to the instake runner... as Katech does not offer that. Stay tuned : )