|
Hello again Huutchh,
Here is a copied excerpt from my 2017 Camaro manual and should give you the info that you need!
Good luck!
Programming with No known transmitters
If two currently recognized transmitters are not available, follow this procedure to program up to eight transmitters. This procedure is not available in Canada. This procedure will take approximately 30 minutes to complete. The vehicle must be off and all of the transmitters to be programmed must be with you.
1. Remove the key lock cylinder cap on the driver door handle. Insert the vehicle key of the transmitter into the key lock cylinder on the driver door handle and turn the key to the unlock position five times within 10 seconds.
The Driver Information Center (DIC) displays REMOTE LEARN PENDING,
PLEASE WAIT.
2. Wait for 10 minutes until the DIC displays PRESS ENGINE START BUTTON TO LEARN and then press ENGINE START/STOP.
The DIC display will again show REMOTE LEARN PENDING, PLEASE WAIT.
3. Repeat Step 2 two additional times. After the third time, all previously known transmitters will no longer work with the vehicle. Remaining transmitters can be relearned during the next steps.
The DIC display should now show READY FOR REMOTE #1.
4. 5.
6.
Place the new transmitter into the rear cupholder in the center console.
Press ENGINE START/STOP. When the transmitter is learned, the DIC will show that it is ready to program the next transmitter.
Remove the transmitter from the cupholder and press K or Q.
To program additional transmitters, repeat Steps 4–6.
|