|
Nice videos. I dropped the whole cradle to the floor, while leaving the driveshaft connected, and used pullers to push the bushings out, and used the same method to install the new ones. I was a chicken about the torch, but that method, probably, saved 5-hours I bet. I think either the front or rear bushings are hydraulic or something though... Regardless - it's obviously affective, and has been done several times with no reports of big issues.
KUDOS for sharing these helpful videos!
__________________
'20 ZL1 Black "Fury"
A10, PDR, Exposed CF Extractor
Magnuson Magnum DI TVS2650R // RFBG // Soler 103 // TooHighPSI Port Injection // THPSI Billet Lid // FF // Katech Drop-In // PLM Heat Exchanger // ZLE Cradle bushings // BMR Chassis-Suspension Stuff // aFe Bars // Diode Dynamics LEDs // ACS Composites Guards // CF Dash // Aeroforce // tint // other stuffs |