Quote:
Originally Posted by Chrome383Z
Another data point I just finished remote tuning mine with Ted.
2650 110mm upper, 8.86” (10%) lower. 9-10 psi at 85F.
LPE HPFP
XDI+30
LT4 w JMS@17.25V
Ended up settling at E70. Ran full E (79%) and injector PW was right at 6.0ms. Ted wanted me to back it down a bit to allow room for COT enable which was off during tuning. High side was holding up to 6700 when I backed out (LT1 pressures). Low side isn’t registering (2019 pid issue I haven’t resolved). E67 was like 5.25ms @ 85F.
I don’t drive the car under 60 deg, but when it cools off to the mid 60s I’ll likely log again to make sure it’s holding well. I could see dropping to E65 in the fall.
Won’t have a chance to put on the dyno for a couple weeks. Tuned at .82 lambda.
|
Even at that boost you should make decent hp over 600. That's a big upper for sure but with the 10% lower its not an issue to make good boost for the street.