That design feels a bit silly, not sure how these make the headlights more secure. They should've fixed the side gaps caused by heat expansion of the plastic bumper instead.
If it's any consolation, pulling the 2016-2018 rear bumper will very likely break the bumper support in the center, under the bowtie, as the glue used for the plastic support plate is weaker than the clips and there is literally 0 access from behind (ask me how I know).
Very nice paint job on your part, however
__________________
2018 Camaro 2SS — G7E MX0 NPP F55 IO6
735 rwhp | 665 rwtq
Magnuson TVS 2300 80mm pulley | Kooks 1 7/8" LT headers | JRE smooth idle terminator cam | LT4 FS & injectors | TSP forged pistons & rods
JMS PowerMAX | DSX flex fuel kit | Roto-Fab CAI | Soler 95mm LT5 TB | 1LE wheels | 1LE brakes | BMR rear cradle lockout | JRE custom tune
1100 - 1/30/18 | 2000 - 1/31/18
3000 - 2/06/18 TPW 2/26/18
3400 - 2/19/18 | 3800 - 2/26/18
4300 - 2/27/18 | 4B00 - 3/01/18
4200 - 3/05/18 | 4800 - 3/14/18
5000 - 3/16/18 | 6000 - 3/19/18