Quote:
Originally Posted by brad65ford
Thank you, I tried this today we another revision from my tuner. No dice unless I'm doing it incorrectly. When you say foot on the floor and press the start and hold it starts. Not sure if there is away around this?
|
I just did this yesterday so you'd think I could write it here:
1. Turn on laptop and plug into OBDII,
2. With foot OFF brake, put car in accessory mode by pushing the start button for a second or two, release, then hold it down until its light turns green, a bunch of dash lights will appear and things will beep,
3. Open HPT and connect to car,
4. Close scanner and open Editor,
5. Select the tune to load and write the file to the car,
6. Exit HPT and turn off the ignition.
7. Put foot on brake and push ignition. It will go "clunk." [mine does anyway because of cam sync] Take foot off brake then back on, push start, vroom.
__________________
2020 ZL1LE A10.
LME LT4 390 short block, LME CID Heads, Kong E2650, FBO.
15" conversion, MT ET Street R 325/15.
100 octane: 1045hp/1055tq.
100 octane + Meth (1x10+): 1117 hp/1067 tq