More prep to drop cradle
73
pop wire holding clip off to access 10mm bolt that holds oil cooler line to pan.
Move cooler line away to get this clip off. Tough one.
Remove cooler lines. Front one stays pull it back out of way. Rear one comes off. Box-1
Remove oil level plug.
Remove 13mm bolt holding oil drain back tube to block. Release tube from pan. I just moved it aside for now.
Remove flywheel lock,(it’s already gone in pic) 10mm bolt and dust shield similar on driver side. They are in drawer of table top chest.
Remove can shaped heat shield and then there is an electrical connector underneath.
74 loosen engine mounts to where you can loosen them with fingers.
75a. Driver side brake scoop remove push pin and separate from inner duct. This one is a little hard because aux radiator scoop is still in place. Two stage push pin.
75b push pin is already removed from previous step remove from inner scoop.
76 more access to cradle remove
Passenger remove 4 t-15 bolts and panel.
Driver same panels are by bumper cover.
|