|
I think he means that the base of the pinch weld is not the same height on each side (of the pinch weld). I noticed this as well when I was installing mine. It makes the lift blocks sit at a slight angle rather than perpendicular to the base.
To the OP. I was concerned about this at first, but it doesn't seem to have resulted in any bending of the pinch weld when the car is raised.
Just make sure to look the base area carefully and ensure it's smooth before you try to mount the lift block. I noticed there were a few places that had raised welding extrusions (imperfections) that would have prevented the block from sitting flat along the length of the lift block. I just simply moved the block 1/2 inch further along the pinch weld till if found a clean (smooth) spot.
|