Quote:
Originally Posted by MartinLe
Hey guys,
I am running JRE's 125 Flex Fuel package. Of course, it's not enough, so-
I am not ready to put a cam in it, but I do want to try a Maggie 2650 on for size. If I installed the bigger blower, what could I safely get out of it with my current setup (or with some minor adds)?
Thanks in advance for your advice.
|
All depends on what your making now, boost etc. your not going to be able to run much E if any at all with the 2650.
660-680 is typical on pump @ 15-16psi. You’ll be out of fuel though on E and at the very end on 93.
If your making 650 now running e50/60 I wouldn’t bother until you put a cam in.
__________________
928rwhp - 93 | 1040rwhp/898rwrq - E65 SAE
LME 377 LT4 Short Block | Magnuson 2650 80mm upper w/13% lower (9.06) | DSX Lid & Valve Covers | CSP Custom Cam w/32% fuel lobe | CID Heads | NW 103mm TB | Roto Fab Big Gulp | CSP 2" Headers w/Green GESI Gen 2 Cats | Borla 3" Full Cat Back w/ S-Type| Mighty Mouse Wild Catch Can| Custom Holley Low side Fuel system| TooHigh PSI Port Injection w/Holley Controller | Forced Inductions Interchiller w/2 gallon fender tank | TK Performance built 10L90