Quote:
Originally Posted by FoundNemo
Got any pics of the CSP headers and 1700hp cats? Not quite sure how they fit a 5" plus body cat under the car where the headers end, space is very tight there.
|
Cars going in their shop next Monday for the install. I’ll have them take pics.
From my understanding is they had them custom fabricated to fit their csp headers. I asked about the fitment on my kooks and your concern about fitting was same as mine. Apparently the kooks are different then theirs as well as the cats themselves which seem custom made for their headers as well.
Its possible kooks will have some sort of fitment to their header in the future. But for now csp/stainless works beat then to the punch this round.
Correct me if I’m Wrong but as of now gesi just has a generic cat and/or the actual barrel they sell.
__________________
928rwhp - 93 | 1040rwhp/898rwrq - E65 SAE
LME 377 LT4 Short Block | Magnuson 2650 80mm upper w/13% lower (9.06) | DSX Lid & Valve Covers | CSP Custom Cam w/32% fuel lobe | CID Heads | NW 103mm TB | Roto Fab Big Gulp | CSP 2" Headers w/Green GESI Gen 2 Cats | Borla 3" Full Cat Back w/ S-Type| Mighty Mouse Wild Catch Can| Custom Holley Low side Fuel system| TooHigh PSI Port Injection w/Holley Controller | Forced Inductions Interchiller w/2 gallon fender tank | TK Performance built 10L90