Quote:
Originally Posted by Jaxcam02
I dig it. Only thing I would say is about the front bumper. its not installed even on both sides. Drivers side hangs over the bend more than the passenger side. I would have them moved back about an inch from that curve in the front bumper.
|
You know what’s funny. I had 2 people look at it in person just now, couldn’t see it. But then I used the pic from Here and they said they noticed it.
But good eye. It’s like 1mm difference on the edge there. I can just tape it and give her a nice slice
__________________
928rwhp - 93 | 1040rwhp/898rwrq - E65 SAE
LME 377 LT4 Short Block | Magnuson 2650 80mm upper w/13% lower (9.06) | DSX Lid & Valve Covers | CSP Custom Cam w/32% fuel lobe | CID Heads | NW 103mm TB | Roto Fab Big Gulp | CSP 2" Headers w/Green GESI Gen 2 Cats | Borla 3" Full Cat Back w/ S-Type| Mighty Mouse Wild Catch Can| Custom Holley Low side Fuel system| TooHigh PSI Port Injection w/Holley Controller | Forced Inductions Interchiller w/2 gallon fender tank | TK Performance built 10L90