Quote:
Originally Posted by cmitchell17
Now that I think about it, if the GESI cats and the stock cats are similar in circular diameter, and if I didn't care about having the supposed stock downpipe bottleneck/restriction then it seems like it shouldn't be too difficult to cut out just the circular section, which it looks like you did, and just cut the circular section out of the GESI cats and weld them back in.
|
Only the primaries are round. Secondaries and completely different.
__________________
928rwhp - 93 | 1040rwhp/898rwrq - E65 SAE
LME 377 LT4 Short Block | Magnuson 2650 80mm upper w/13% lower (9.06) | DSX Lid & Valve Covers | CSP Custom Cam w/32% fuel lobe | CID Heads | NW 103mm TB | Roto Fab Big Gulp | CSP 2" Headers w/Green GESI Gen 2 Cats | Borla 3" Full Cat Back w/ S-Type| Mighty Mouse Wild Catch Can| Custom Holley Low side Fuel system| TooHigh PSI Port Injection w/Holley Controller | Forced Inductions Interchiller w/2 gallon fender tank | TK Performance built 10L90