[Spaceme1117]

So I changed my HID bulbs the day before. I had to temporarily remove my Rotofab intake to get to the drivers side headlight.

Put everything back and tightened all the intake clamps.

Next day, my car would not remote start.

Got in the car and started it and had a CEL. Code P2227 and P00C7. Code P2227 is "Barometric Circuit Range/Performance". Not sure what the P00C7 is.

When I installed the Rotofab originally, I disconnected the battery for 30 minutes. I have put over 3000 miles on the car since then and no problems.

I was able to get the CEL to turn off by disconnecting the battery again for 30 minutes but the codes are still there.

Only thing I can think that happened is that I had a small air leak originally (I noticed one of the clamps seemed a bit loose). And when I reset the adaptations by disconnecting the battery, the air leak was part of the adjustment. Now after taking the intake apart then re-installing, I fixed the air leak but now the ECU adaptations were out of range. (The reverse may also be possible).

From what I have read, the permanent codes will likely go away after a few drive cycles.

Going to get some significantly better clamps from McMaster Carr to make sure I don't ever have any air leaks.

Anyone ever encountered this before with a RotoFab or other intake?

Any help, advice, or knowledge sharing is appreciated.

Edit/Update: So I was re-checking things on the intake to see if there was any thing I missed. Looks like the elbow that screws into the bottom of the intake tube and that connects to the PCV thingy (square-ish plastic part) was a bit loose. I guess when I installed it originally, I forgot to thread it in until it was tight. Likely been leaking a small bit this whole time.

I disconnected the battery again to reset everything so hopefully, I found what the problem is.

Still interested in people sharing their knowledge on these permanent codes.