CAMARO6 - View Single Post - What did you do to your 6th Gen Camaro today?!

DannyC · 05-29-2021, 10:20 AM

It wasn't exactly today but I did solve a major tuning issue today. Installed a Magnuson 2650 last week and have been using HP Tuner software to get it dialed in. Everything was fine except I could tell the air was off meaning it wasn't reading air flow correctly. I couldn't figure if it was my MAF or the new LS9 MAP sensor that comes installed on the blower.

My bud at Goat Rope Garage suggested the scaling on the MAP sensor could be off so did a little research and found the scaling for the LS9 MAP sensor was waay different than the stock SS MAP sensor. Plugged the right numbers in and BAM it runs like factory again only with way more power

Now all I have to do is finish the water/methanol injection installation.

05-29-2021, 10:20 AM	#10332
DannyC Drives: 17 Camaro SS Join Date: Nov 2019 Location: Central VA Posts: 122	It wasn't exactly today but I did solve a major tuning issue today. Installed a Magnuson 2650 last week and have been using HP Tuner software to get it dialed in. Everything was fine except I could tell the air was off meaning it wasn't reading air flow correctly. I couldn't figure if it was my MAF or the new LS9 MAP sensor that comes installed on the blower. My bud at Goat Rope Garage suggested the scaling on the MAP sensor could be off so did a little research and found the scaling for the LS9 MAP sensor was waay different than the stock SS MAP sensor. Plugged the right numbers in and BAM it runs like factory again only with way more power Now all I have to do is finish the water/methanol injection installation. __________________ Flow Tech axle back, Roto-Fab, Nick Williams 103, AEM Wide Band, Defrost vent pod, billet catch can, BBK long tube headers and NGK LTR6GP, #90198, one step colder, Magnuson 2650, Snow Performance water/methanol injection. (Also tune myself w/HPTuners)