Quote:
Originally Posted by FoundNemo
Might want to check the muffler you used just fyi. Some of the Maggie X Mufflers go down to a single 3" pipe inside (double Y) instead of a normal X merge.
|
I know this is old, but your right. This muffler isn’t a true X , it’s a double Y. The inlets and outlets connect in the center to a single 3” pipe. Granted it’s only 2” long before it exists back to dual. I just don’t know if this is a good idea now and if it going to affect flow.
Then again its 3”, bigger then stock pipe and also if there’s no power loss with the crushed stock pipes this should probably be fine.
__________________
928rwhp - 93 | 1040rwhp/898rwrq - E65 SAE
LME 377 LT4 Short Block | Magnuson 2650 80mm upper w/13% lower (9.06) | DSX Lid & Valve Covers | CSP Custom Cam w/32% fuel lobe | CID Heads | NW 103mm TB | Roto Fab Big Gulp | CSP 2" Headers w/Green GESI Gen 2 Cats | Borla 3" Full Cat Back w/ S-Type| Mighty Mouse Wild Catch Can| Custom Holley Low side Fuel system| TooHigh PSI Port Injection w/Holley Controller | Forced Inductions Interchiller w/2 gallon fender tank | TK Performance built 10L90