|
The mods' to the valve covers are easy. It took me just as long to remove and reinstall as the cutting. It would go faster if you have a band saw probably, but I used a sawzall, and cleaned the cuts up with a Dremel, and it was totally fine. I'd just make sure to tape-off all the openings and keep everything clean so you don't drop crap into the top of the engine. It was a little scary, but it was fine after the first cut was done, HAHAHA. If you can change your oil, you can probably do this.
__________________
'20 ZL1 Black "Fury"
A10, PDR, Exposed CF Extractor
Magnuson Magnum DI TVS2650R // RFBG // Soler 103 // TooHighPSI Port Injection // THPSI Billet Lid // FF // Katech Drop-In // PLM Heat Exchanger // ZLE Cradle bushings // BMR Chassis-Suspension Stuff // aFe Bars // Diode Dynamics LEDs // ACS Composites Guards // CF Dash // Aeroforce // tint // other stuffs |