View Single Post
Old 11-09-2020, 07:39 AM   #27
Elite Engineering


 
Elite Engineering's Avatar
 
Drives: 2010 Camaro
Join Date: Nov 2009
Location: Denver
Posts: 1,383
Great to see someone do the test on here, but the way your conducting it wont show what gets past each can to still be ingested. What a can traps is not nearly as important as what gets past, so here are the details on how to conduct the test, and a minimum of 1,000 miles, and 2,000 miles is far more accurate.


The entire reason for the test is to test effectiveness. Most people install a system on their engine to prevent the ingestion of the oil and other combustion byproducts. So you must start out with both cans empty and clean of all residue. And the cans MUST be run in series. The second can MUST be hooked up so the outlet from the first is connected to the inlet of the second. If not there is no way to determine what gets pulled through the first can to be trapped by the second, and then when reversed, the same thing. Here is an actual video again by a completely independent tech that shows every step of the test:




Any questions, please ask us, and again, thanks for taking the time to do this.


Sales@EliteEngineeringUSA.com and Tech@EliteEngineeringUSA.com






Also, we notice your not using the Venturi valve for secondary evacuation suction source. Your using the fresh/clean side source which MUST be routed through the oil sump tank to work properly and generates no usable vacuum, so your only using half of our system, which will do nothing when in boost/WOT. Our instructions show how to properly route the can, and it cannot work as your doing. To be clear, you MUST use a proper secondary vacuum source. I assume your thinking the secondary suction source is generated by a restricted air filter, and that is absolutely incorrect. You MUST use and actual Venturi effect vacuum generating barb as shown here:




And the checkvalves MUST be on both outlets flowing away from the can. Hooking it up as you have it it can't work. Your mixing clean and dirty sides together defeating the function.


Just ask or visit our website to find instructions. This must be conducted equally and fair and to hook ours up incorrectly, is not really fair. Also, something doesn't look right on your connections?
Elite Engineering is offline   Reply With Quote