CAMARO6 - View Single Post

squish72 · 11-07-2020, 12:13 AM

Finally received my intake, think I'm going to do minimal porting to it as everything feels really good. Most of the seams in the plastic seem like they step up larger, so the air seems like it wouldn't be affected much.

I also have a 95mm throttle body and dont think I'll actually be putting it on for two reasons.

#1 the altitude I'm at I don't have an issue with map vs ambient air as it is. My altitude is 6400+ and I don't believe throwing a larger throttle body will do much.

#2 I saw the intake is kinda thin on the throat so you cant fully open it up to utilize 100% of the 95mm.

I have access to a milling machine so the TB wont need a adapter if I do decide down the road to install it. I also machined some ofr the cross bar in it just like I did on my stock one.

11-07-2020, 12:13 AM	#85
squish72 Drives: 2016 2SS 8AT Join Date: May 2018 Location: Nevada Posts: 358	Finally received my intake, think I'm going to do minimal porting to it as everything feels really good. Most of the seams in the plastic seem like they step up larger, so the air seems like it wouldn't be affected much. I also have a 95mm throttle body and dont think I'll actually be putting it on for two reasons. #1 the altitude I'm at I don't have an issue with map vs ambient air as it is. My altitude is 6400+ and I don't believe throwing a larger throttle body will do much. #2 I saw the intake is kinda thin on the throat so you cant fully open it up to utilize 100% of the 95mm. I have access to a milling machine so the TB wont need a adapter if I do decide down the road to install it. I also machined some ofr the cross bar in it just like I did on my stock one. Last edited by squish72; 11-07-2020 at 06:30 AM.