Quote:
Originally Posted by 7LitreC5
Cool. I have a couple of questions.
Does it snap into the dash just like the stock vent?
How does the trim ring attach to your part?
The stock vent is deeper. Does your mount attach to the stock vent or replace it?
How does the gauge attach to your mount?
Thanks
|
This pod directly replaced the stock vent/diverter. The factory vent/diverted is captured by a spherical bore (socket). The two halves of the socket are most likely fused at the seam during production after the vent/diverted is in place.
The trim ring is attached to the factory vent housing.
This mount goes inside of stock vent housing.
The gauge attached to the mount using the supplied clamp provided by the garage manufacturer. Slide the gauge through the front and the clamp in the rear has two plastic thumb screws the keep the gauge in place.
https://www.camaro6.com/forums/showt...php?p=10772205
__________________
Roto-Fab w/sound tube delete, Katech ported TB, Pray IM, Velossa, DD side markers, DSX FF, UPR Catch can, Halo brace, My custom vent gauge pod
Originally Posted by arpad_m - “Aww, yet another oil thread with almost the same question in the OP“