[ember1205]

Originally Posted by Bumbleboy92

I didn’t see the wires much but maybe you can, here’s my video from back when I had the console apart

For yours, it appears that it's an oversized plastic molded plug with just the mini-USB connector in it. I'll have to pull mine apart to see what it looks like since there are definitely some differences...

I'll probably try and take a look tomorrow. Lifting the console only takes five minutes (remove the knee pads, two bolts on each side up front, push the seats all the way forward, one more bolt on each side behind the covers, pop the rear seat up, and you can lift the console for access to the module). Once I get the module out and the wires unclipped, I'll be able to better tell what I might be dealing with for wiring.

UPDATE: It takes less than 20 minutes to remove the knee pads, the six screws, pop the rear seat, lift the console, disconnect the USB wire, and then put it all back together again. And, as I suspected, you do NOT need to unclip the shift boot to do any of this - that's only necessary if you're completely removing the console for some reason.

My USB connector is the same - a single mini-USB plug in a very large plug mold that clips into the module.