CAMARO6 - View Single Post

SilverCamaroVert · 05-28-2020, 01:41 PM

It's a sad situation.

From my discussion with support:

Code:

So I'm assuming the plan is to rework your pcb design but are trying to rework these ones

Correct, and in combination with new software, that did seem to address the start-up issues.

ok, so how do I get a proper new pcb? I do not want this reworked unit.

I don't really know when we will switch to a new board. For the time being we have quite a lot of these boards.

so as you can see, they are shipping new units with these repairs and don't know when they are switching to new boards.

Kind of a crapshoot. Maybe PAC will make a module within a year. IDK. In my case, I had already converted my car to requiring this module. I would have to rewire a bunch of stuff again.

The module sounds great in honesty. I would HIGHLY recommend it if it wasn't for this repair. An electrical engineer friend said it was a poor repair but should hold. He recommended I epoxy the wire to the board to keep it from stressing over time.

05-28-2020, 01:41 PM	#31
SilverCamaroVert Drives: 2019 LT3 RS Convertible Join Date: Sep 2018 Location: New Hampshire Posts: 126	It's a sad situation. From my discussion with support: Code: So I'm assuming the plan is to rework your pcb design but are trying to rework these ones Correct, and in combination with new software, that did seem to address the start-up issues. ok, so how do I get a proper new pcb? I do not want this reworked unit. I don't really know when we will switch to a new board. For the time being we have quite a lot of these boards. so as you can see, they are shipping new units with these repairs and don't know when they are switching to new boards. Kind of a crapshoot. Maybe PAC will make a module within a year. IDK. In my case, I had already converted my car to requiring this module. I would have to rewire a bunch of stuff again. The module sounds great in honesty. I would HIGHLY recommend it if it wasn't for this repair. An electrical engineer friend said it was a poor repair but should hold. He recommended I epoxy the wire to the board to keep it from stressing over time.