CAMARO6 - View Single Post - Installing Borla Mid-pipes (#60610)

oldman · 05-02-2020, 05:01 PM

I put a 60608 (which is a resonator version of the straight pipe) in a stock exhaust system (all four cats inplace). I had to use two pieces of wood to spread the piping a little and the just slid in place. AFAIK you can't install it backwards because the pipes are only flared at one end.

05-02-2020, 05:01 PM	#2
oldman Drives: SS 6 speed of course Join Date: Jan 2016 Location: Hilo, HI Posts: 4,346	I put a 60608 (which is a resonator version of the straight pipe) in a stock exhaust system (all four cats inplace). I had to use two pieces of wood to spread the piping a little and the just slid in place. AFAIK you can't install it backwards because the pipes are only flared at one end. __________________ Forged short block, large duration sub .600 lift Cam Motion cam, 7200 RPM fuel cut, Pray Ported Heads, 3.85 pulley D1X, stage II intercooler, DSX secondary low side, DSX E85 sensor, Lingenfelter big bore 2.0 pump, ported front cats, 60608 Borla, LT4 injectors, ZL1 1LE driveshaft and Katech ported TB, ported MSD intake, BTR valvetrain, ARP studs, ProFlow valves, PS4 tires.