Quote:
Originally Posted by Mike@SolerPerformanceLLC
Thank you very much, 20Bluezl1.
We cannot take the stock 87mm, or our version of it at 91mm, up to 103mm. We are going to be releasing our own 103mm (maybe 107mm TBD) with the same or better partial throttle airflow gains (response) as our current products.
These large TB's are made for those near or above 1000 cranck HP's. Going larger than needed might even backfire.
We also have the ZR1 TB originally 95mm taken to 100mm plus the partial throttle airflow gains that make them respond so well. This is good up to 900 crank HP's.
|
Sounds great, I'm not looking to go anywhere near 1000 crank. Just looking at maybe ported blower, roto fab,headers, cat delete, upper and lower pulley and maybe interchiller
