Quote:
Originally Posted by MP3BOOSTED
pulling the motor isn't that hard of a task to complete. Pray could spec out a more power driven cam though i would say, I did pretty much the same setup as OP but with the vvt3 cam and being a manual car.
If i could go back i would go with a bigger cam by pray with johnson racing lifters for added security as the ls7 do tend to fail on you.
|
__________________
Forged short block, large duration sub .600 lift Cam Motion cam, 7200 RPM fuel cut, Pray Ported Heads, 3.85 pulley D1X, stage II intercooler, DSX secondary low side, DSX E85 sensor, Lingenfelter big bore 2.0 pump, ported front cats, 60608 Borla, LT4 injectors, ZL1 1LE driveshaft and Katech ported TB, ported MSD intake, BTR valvetrain, ARP studs, ProFlow valves, PS4 tires.
|