[1hprush]

Originally Posted by Warrior102

I removed mine on a hot sunny day in August, peeled right off. Open the hood, pull the plastic push pins holding the liner, remove the 8 - 10mm (don't recall) nuts holding the vents, grab an edge and start peeling. This time of year a bit of heat would probably be needed, a hair dryer would probably suffice. The hood was pretty free of adhesive, there was a bit around the edges easy removed with alcohol.

If you change your mind any car wrap shop can replace it for short money, if I were to ever replace it (not likely) I would go with a satin rather than the flat black.

Thanks, I like the satin version too and may end up going that route.