[JANNETTYRACING]

Something else I would like to add regarding the air intake sensor as a fail safe or for monitoring actual IAT.

I see so many people install the Air temp sensor right after the meth nozzle or just on the other side of the TB in the entry of the intake.

That placement in my opinion is too close and will not give real data.

The Sensor should be placed in the rear most portion of the intake and never make contact with any liquid.

It is an Air temp sensor and should not be used as a liquid sensor.

By being place in the rearmost portion of the intake furthest from the meth nozzle you will get real IAT readings that are entering the intake ports.

To many are bragging about how low thier IAT is after install WM with the sensor in the path of liquid.

Plus Depending on the tune may be falsely adding timing which can be catastrophic.