CAMARO6 - View Single Post

oldman · 01-15-2020, 01:44 PM

http://www.cammotion.com/gen-5-lt-ca...ger-camshafts/

Cam Motion is the only people I know that make a specific centri cam. You can order any duration and any lobe profile. I went with a sub .600 lobe.

I went with a 230+ duration cam just cause I WANTED the lope, my original zero overlap Pray stage 1 or 0 depending was just too mild, very hard to tell it was NOT stock. The Cam Motion defined lope cam leaves no doubt.... was not a power mod. I have an m6 and feel the cam is completely totally drivable...

I have a idle / rev video on the NA section. Will do one soon with a 100% stock exhaust system, at 45 MPH it really behaves and sounds like stock. In the parking lot it sounds like a BIG cam even with a near stock exhaust.

01-15-2020, 01:44 PM	#13
oldman Drives: SS 6 speed of course Join Date: Jan 2016 Location: Hilo, HI Posts: 4,346	http://www.cammotion.com/gen-5-lt-ca...ger-camshafts/ Cam Motion is the only people I know that make a specific centri cam. You can order any duration and any lobe profile. I went with a sub .600 lobe. I went with a 230+ duration cam just cause I WANTED the lope, my original zero overlap Pray stage 1 or 0 depending was just too mild, very hard to tell it was NOT stock. The Cam Motion defined lope cam leaves no doubt.... was not a power mod. I have an m6 and feel the cam is completely totally drivable... I have a idle / rev video on the NA section. Will do one soon with a 100% stock exhaust system, at 45 MPH it really behaves and sounds like stock. In the parking lot it sounds like a BIG cam even with a near stock exhaust. __________________ Forged short block, large duration sub .600 lift Cam Motion cam, 7200 RPM fuel cut, Pray Ported Heads, 3.85 pulley D1X, stage II intercooler, DSX secondary low side, DSX E85 sensor, Lingenfelter big bore 2.0 pump, ported front cats, 60608 Borla, LT4 injectors, ZL1 1LE driveshaft and Katech ported TB, ported MSD intake, BTR valvetrain, ARP studs, ProFlow valves, PS4 tires.