[DannyC]

Finally finished up the AEM wide band and the defrost pod. Man that thing was a pain. You are supposed to drill a hole in the vent tube some where and run the wires through cus the hole in the bottom of the pod is at the front instead of the back where you have a gap between the dash and the vent tube.

I had already run the wires on the outside the tube at the rear but then couldn't get the pod into the hole cus the wires were hitting the vent tube. Couldn't find a way to drill the tube so I took a rotary tool and cut a grove into the tube about an inch and slid the wires in, then shoved the pod in and down until it stayed in. It takes about 1000lbs of pressure lol