Quote:
Originally Posted by Alain
Anyone have any issues with the car going into limp mode after installing this thing?
I have their throttle body installed already, I'm waiting to see if there are any issues with this controller sending the car into limp mode.
I know that has been an issue in the past with other controllers.
|
Like Termite said, above. Follow the instructions, make sure, after ignition is off, that all doors including trunk you need open for the installation, are open. Then wait 10 min so the ECM cuts power to the ETC system. Install.
If you get a code or limp on the first start, then disconnect the battery for 10 min and check the connections (red tabs out, push until you hear a click, push red tabs in). This will also give the ECM an opportunity to relearn minimum pedal position value.
Zero problems after this.
Out of hundreds of units, there is always one that will be bad, it happens, but you do not have anything to worry about. We'll send you a replacement right away (and prepaid return label) or a full refund if you prefer.