Quote:
Originally Posted by Jaxcam02
I've read multiple times on the forum that pan bolts not being torqued from factory correctly. Tighten them up, clean it up and check again in a week.
|
Ok thanks guys, I crawled back under there and sure enough almost all of them were loose. Makes me second guess my cam install and worried about my engine and what else the factory "forgot" to do haha
I got my torque wrench and torqued them to 25 Nm for the 13mm and 12 Nm for the 10mm according to the sequence in the service manual as best I could. A few of them I had to use a gear wrench to tighten and not the torque wrench since I couldnt get it in there.