[L78toLT1]

Originally Posted by Booher

Yup, all good, they just adjusted it a little, said it was really easy, I figured, I was just over it heh. Still has a little rattle, I'll attend to that after I get my tuning dealt with. At some points in my wiggling, the headers were further away from the motor than the any bolt would allow easily, at least from what I could tell. I did have a jack stand on the bottom of the collector holding some of the weight.

I had some interference between the drivers side header and the motor mount that caused a rattle like vibration when I reinstalled my headers after pulling the motor last winter. I had not experienced this after the initial header installation. I loosened the bolts and lifted up on the collector to eliminate the contact. It's still close, maybe .125 or so, but it never hits.