Quote:
Originally Posted by TheBusDriver
I haven't had an issue, I have that exact same 3rd brake light. ENORMOUS pain in the ass to clean all that adhesive left behind from the old one, but once clean it fit fine. There is some play where you could install it off to one side or the other, so do your best to center it.
I used the clips that came with the new one.
1) Are you sure you've gotten the surface totally clean?
2) It may be difficult to apply new adhesive correctly; the third brake light comes preinstalled with it, and I feel like if you mess it up it will be very difficult to remove and re-adhere with new adhesive.
3) It's possible you have a bad/mis-formed part.
|
Yeah the surface was totally clean, was very thorough with it. I ordered a real thin 3m adhesive on amazon, that should be easier to apply than what I did last time which was take a razor and cutting a thicker roll.
Quote:
Originally Posted by Mov Ov3r
I have the same 3rd brake light as well with no issue or problem. Maybe a picture of the offset you are seeing vs OEM fitment?
|
Yeah I’ll get a pic in a bit, I’m almost done with work.