Quote:
Originally Posted by oldman
2110, to be realistic with my sub .600 cam and gentle ramp profile, LS7 may be absolutely fine. I probably would go with 2116 is I had a bigger cam or even one of the axle oiling setups. at some point, the plastic tray is going to fail, at some point, you are going to need a roller rocker too. So instead of getting into the cubic $$$$ club, I just went with a lower lift cam and a gentle ramp. 30 HP here, 30 Hp there is no big deal on a street car since traction is not available. i.e. ain't going to make the car faster.
|
Yeah I'm trying to decide on spending $2000+ on pistons and rods and $600ish on new lifters or juts buying a forged short block.
Sent from my SM-G955U using Tapatalk