Building a FOAM CANNON Kit from Scratch
I'm starting from scratch and looking for your suggestions on what to purchase for effective foam cannon washing & drying. I don't have a foam cannon or even a pressure washer, so this will be a ground up set of purchases.
Some questions to get us started and any additional tips from the gurus here are much appreciated:
- Is there a consensus on the best foam cannon?
- How about a recommended pressure washer? I'm thinking electric for ease, but am open to gas powered if that is generally preferred. Any particular specs necessary?
- What foam are most people using?
- How does everyone feel about touchless drying (i.e. no microfiber towels) and instead air drying? What are you using to dry the vehicle after foam & rinse?
Thanks!!
__________________
2019 ZL1 1LE | M6 | SGM | PDR | CF Dash | Nav | Wheel Locks
PPF | Paint Correction | ZL1 Addons Rock Guards | ZL1 Addons Lift Pads | ZL1 Addons Feather Lite Tow Hook | JWM Smoked Sidemarkers | Wildhammer Smoked Rear Reflectors | JWM License Plate LEDs | RotoFab CAI | ADM IC Reservoir v2 | BC Forged RZ05 | SPL Toe Arms | BW Brake Deflectors | CMS Roll Bar | Schroth Profi II ASM Harnesses
.
Sold: '99 Trans Am (bolt-ons & cam) | '00 WS6 (bolt-ons, heads, cam, 12 bolt) | '05 CTS-V (bolt-ons, short throw) | '10 SS/RS M6 (short throw, CAI, coilovers, LTs, catback, JRE tune) | '01 WS6
YouTube
|