CAMARO6 - View Single Post

Dysan911 · 04-19-2019, 11:22 AM

Honestly by far the finickiest gauge I have ever had is in fact the Aeroforce. It works great when its working but a couple things I had to get use too.

1. If you ever need to click the SETUP. It wipes out the Annunciation feature everytime. Lets say you go into setup to add a new PID. When it restarts the Gauge you get a message. "Annunciator is not Setup".

2. Setting up Cyclic Scan. Always results in after you complete selecting all the entries the gauge will go into a constant Reboot Loop. No way to get it out of that so I have to just shut the car off. Leave the car for like 20 or 30 mins. When I get back in then Cyclic scan suddenly starts to work again. I assume when the gauge is left off for a while it resets the ram or something.

and now 3. After the firmware the "Boost inHG PSI" PID no longer works with the LT4 3 Bar Map. FrostySS already mentioned this PID works no problem with other scanning products like the Torque App on Android.

I think Aeroforce is run by one single guy anyway so he's probably annoyed he can't explain why the Boost Pid worked before and not now and won't respond.

04-19-2019, 11:22 AM	#42
Dysan911 Drives: 2017 50th Anniversary 2SS Join Date: Sep 2016 Location: Jacksonville, FL Posts: 930	Honestly by far the finickiest gauge I have ever had is in fact the Aeroforce. It works great when its working but a couple things I had to get use too. 1. If you ever need to click the SETUP. It wipes out the Annunciation feature everytime. Lets say you go into setup to add a new PID. When it restarts the Gauge you get a message. "Annunciator is not Setup". 2. Setting up Cyclic Scan. Always results in after you complete selecting all the entries the gauge will go into a constant Reboot Loop. No way to get it out of that so I have to just shut the car off. Leave the car for like 20 or 30 mins. When I get back in then Cyclic scan suddenly starts to work again. I assume when the gauge is left off for a while it resets the ram or something. and now 3. After the firmware the "Boost inHG PSI" PID no longer works with the LT4 3 Bar Map. FrostySS already mentioned this PID works no problem with other scanning products like the Torque App on Android. I think Aeroforce is run by one single guy anyway so he's probably annoyed he can't explain why the Boost Pid worked before and not now and won't respond.