CAMARO6 - View Single Post - Check Engine Light After Small Modifications

RSC · 03-04-2019, 11:16 AM

Hey guys. I got the Borla #60611 put on my 17 RS yesterday. (I already had the ATAK Axleback since a while back.) Shortly after putting the #60611 (driving about 100ish miles) my CEL comes on. I call onstar & it says I have code P0430. I call Borla & they say that a CEL is expected with this part unless tuned. I'm went back to the Meineke that installed the exhaust & they say I need a tune too. I had them check & there is no exhaust leak or loose/missing O2 sensor. Also side note, with this setup so far I have a lot of vibrating/rattling. Any ideas as to both these issues?

03-04-2019, 11:16 AM	#20
RSC Drives: 2017 Chevrolet Camaro RS 2LT Join Date: Feb 2019 Location: Tampa Posts: 6	Hey guys. I got the Borla #60611 put on my 17 RS yesterday. (I already had the ATAK Axleback since a while back.) Shortly after putting the #60611 (driving about 100ish miles) my CEL comes on. I call onstar & it says I have code P0430. I call Borla & they say that a CEL is expected with this part unless tuned. I'm went back to the Meineke that installed the exhaust & they say I need a tune too. I had them check & there is no exhaust leak or loose/missing O2 sensor. Also side note, with this setup so far I have a lot of vibrating/rattling. Any ideas as to both these issues?