Glad its done - I say run it until it breaks and then take it in to the dealer under warranty and let them find the welds lol
The .249 reamer probably worked as in a drill chuck you will have a little run out.
As far as the depth, you would have to overdrill the depth by 30% to make up for the tip if the drill itself, then about another .1" for the chamfer on the reamer. So basically you would have to be 1" deep to be flush on the pin
__________________
2018 1SS 1LE / HBM - ECS Novi 1500 S/C Tuned by Carl @ CJ Tunes
|