[Reelgrinder]

Currently I have a 2016 SS with an Eforce 2300, Headers, Rotofab, and Borla ATAK.

I want to pull the blower off and add the LT4 Hi side pump, LT4 injectors, and the DSX low side pump..

1. While the blower is off I want to add ported LT4 heads ( The LT1s are 59cc and the LT4 are 64cc) what will the compression change to?

2. Will the LT4 heads bolt on to the LT1 block with no problems?

3. Will LT4 head gaskets work?

4 I was told that the eforces are drilled to accommodate both LT1 and Lt4 heads?

5. I don't plan on changing the cam yet but, would it do any good to do the DOD delete and run LS7 lifters and trays or can you not do this until you do the cam and mess with the limiter?

Thanks in advanced.